buc
kle
storag
e
Harness straps are at,
or slightly below,
child’s shoulders.
Using Symphony™ in the
Rear-facing Position
18
25 mm (1 inch)
or more
Child Requirements
Weight:
2.3 to 18 kg (5 to 40 lbs)
Height:
48 to 94 cm (19 to 37 inches)
AND
the
top of child’s head is at least 25 mm (1 inch)
below the top
of the child restraint headrest
in either of its two lowest positions.
SureLatch
Connector
Rear-facing
Belt Path
1. Secure child restraint to the vehicle seat.
a
Restraint is securely locked in
Recline Position #1
(p. 53).
a
Locking clip is installed, if necessary (p. 55).
a
The level line is level with ground (p. 24/28).
A towel/small blanket is rolled up and placed be-
neath the front edge of the base, if necessary.
a
Child restraint is securely installed with one of the
following methods using the
rear-facing belt
path
:
• SureLatch Connectors (p. 20)
• Quick Connectors™ (p. 20)
• Vehicle Seat Belts (p. 26)
Note:
To determine which type of lower anchor
connector is on your child restraint, go to page 20.
2. Place the child in the child restraint.
a
The child’s back and bottom are flat against the
back and bottom surfaces of the child restraint.
a
Top of child’s head is at least 25 mm (1 inch)
below the top
of the child restraint headrest in
either of its two lowest positions.
3. Make necessary adjustments.
a
Red harness tabs
MUST
be at, or slightly below,
shoulder level (p. 14).
a
Headrest is adjusted to either of the bottom two
positions closest to the harness tabs (p. 53).
4. Fasten both buckle tongues.
Refer to page 14.
5. Position and connect chest clip.
a
Chest clip
MUST
be placed at armpit level (p. 15).
6. Check your work.
a
Harness straps are snug against the child’s shoul-
ders, with no slack (p. 15).
a
To properly secure this child restraint, it
MUST
NOT
move more than 25 mm (1 inch) from
side to side
or
front to back
at the rear-facing
belt path.
Rear-facing Installation Checklist
19
Rear-facing
T
ip
!
T
IP
!
T
IP
!
To make installation easier, watch the installation
video of this child restraint at
www.evenflo.com
.