110
111
bucklestorage
PLACE A
T ARMPIT LEVEL
SENSOR
SAFE
The aircraft seat belt must be as tight as possible.
Route the excess seat belt strap back through the
belt slots, as shown above. Using your full weight,
push the child restraint firmly onto the aircraft seat
while pulling on the excess seat belt strap to tighten.
Check your work.
Try to move the child restraint
in all directions. If you can move the child restraint
more than 2.5 cm (1 in.) side-to-side or front to
back at the belt path, the aircraft seat belt is not
tight enough, and you
MUST
install again until the
seat belt is tight.
Installing Carrier WITHOUT Convenience
Base in Aircraft (cont.)
5
Installing Carrier without Convenience Base
in Aircraft (cont.)
Squeeze both handle
releases and move
the handle to
Position 1
.
Position 1
6
As a final step, unfasten the
chest clip (p. 79).
In order to comply with the
FAA regulation for Portable
Electronic Devices (PED), the
SensorSafe Chest Clip
MUST
be unfastened before take-off.
7
Note:
After landing, fasten the SensorSafe Chest Clip
before removing the LiteMax Infant Car Seat from the
Aircraft seat.
Unfasten SensorSafe
Chest Clip
