Evenflo LITEMAX GOLD, Руководство пользователя

Страница: 52 / 65

102 103
1. INSTALL THE SENSORSAFE TM RECEIVER.
Locate the 16PIN OBDII port
a
in your vehicle. Refer
to your vehicle owner’s manual for location. Plug in the
SensorSafe
TM Receiver.
2. POWER UP THE VEHICLE.
If unable to locate your vehicle
manual, the SensorSafe
TM
Application may contain
information regarding the
location of the 16PIN OBDII port
for your vehicle
Your SensorSafe
TM Receiver will
sound one prolonged tone
when it first communicates with
the vehicle network. In some
vehicles this occurs immediately
after installing the SensorSafe
TM
Receiver, in other vehicles the
tone will not be heard until the
vehicle has been started.
This initialization signal only
occurs one time after installation.
a
USING SENSORSAFE 2.1 USING SENSORSAFE
TM
3. CYCLE THE SENSORSAFE TM CHEST CLIP.
Your SensorSafe
TM
Chest Clip is designed to “go to sleep” if
clipped for more than 12 hours. To reset,
or “wake up” the chest clip, unfasten then
re-fasten it. When you do this, the blue
LED will flash two times. TO PRESERVE
BATTERY LIFE, ALWAYS STORE THE
SENSORSAFE CHEST CLIP IN THE UNCLIPPED POSITION.
4. DRIVE THE VEHICLE.
The SensorSafe TM Receiver is designed to respond after the
vehicle has been driven at 5 miles per hour or more.
5. PARK THE VEHICLE AND TURN OFF THE IGNITION.
Within 2 seconds of parking your vehicle and turning off the
ignition you will hear the SensorSafe
TM
reminder, alerting you
that your baby is in the vehicle. If you don’t hear the reminder
tone, test your SensorSafe
TM
by following steps 1-5 again.
Contact Evenflo’s ParentLink at: 1-800-233-2229 in the (U.S)
and (Canada), or online at:
www.evenflogold.com
or
www.
evenflogold.ca
if the reminder tone again fails to sound.
Note:
SensorSafe
TM
Receiver will also alarm if your child
unclips the Chest Clip after the vehicle has been driven at 5
miles per hour or more, but only if the vehicle is on.
PLACE AT ARMPIT LEVEL
SENSOR
SAFE
USING SENSORSAFE
TM
(CONT.)