Installing the Embrace Base with your
Vehicle Seat Belt
21
8
Move the handle
A
to the “carry” position by squeezing in
on both handle releases
B
and rotating the handle until it
locks into place above the carrier.
Squeeze the carrier release handle
C
while lifting up the
carrier.
Releasing the Carrier
from the Base
Move the handle to the “car” position by squeezing both
handle releases
L
and rotating the handle until it locks
into place behind the carrier.
Ensure there is at least 1 1/2 inches (38 mm) of space
between any part of the carrier and the vehicle seat that
is closest to the child’s head. You may need to rotate the
handle further down to the “stand” position to provide
enough room.
L
➚
L
A
C
B
20
If you have fully ad-
justed the base and
it is still not level, use
a tightly rolled towel
or small blanket
K
underneath the front
edge of the base.
You need to provide
enough recline for
an infant’s head to
lie back comfortably.
Check the level indicator
B
again to make sure the base is
still level.
If the base is not level, repeat steps 1 – 5.
Secure the carrier to the
base by placing it into
the base and pressing
down on the front and
back. The carrier
MUST
be locked firmly into the
base. Check by lifting up
on the carrier handle.
5
➚
6
K
7
Vehicle
must be on a
level surface.
T
ip
!
T
ip
!
B
