1986-1996 TOYOTA 4-5” KIT
Thank you for choosing Rough Country for all your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the product layout on the last page
on these instructions. Be sure you have all needed parts and know where they go. Also please review tools needed list
and make sure you have needed tools.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Seat belts and shoulder harnesses should be worn at all
times. Avoid situations where a side rollover may occur.
Generally, braking performance and capability are decreased when larger/heavier tires and wheels are used. Take this
into consideration while driving. Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height
over the intended height of the Rough Country product purchased. Mixing component brands is not recommended.
Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will not be re-
sponsible for any product that is altered.
If question exist we will be happy to answer any questions concerning the design, function, and correct use of our prod-
ucts.
This suspension system was developed using a Maximum tire size
of
33X12.50 on 8” wheel with 3.75” back spacing.
Note
if wider tires are used, offset wheels will be required and/or trimming may be required.
Please note that a variation in the rear block and u-bolts exists for this application. 1986-96 short bed standard
cab models require part #s 1733BOX1 & 1734BOX1. All other pickup applications require 1733BOX1 &
1733BOX2. Please verify that the correct box kits are present before beginning the installation process. If you
have any question please call technical assistance at 731-285-9000.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi-
cle of its unique handling characteristics.
INSTALLING DEALER - it is your responsibility to install the warning decal and forward these installation instructions on
92173300
22mm Wrench
21mm Wrecnch
12mm Wrench
19mm Wrench
17mm Wrench
24mm Wrench
15mm Wrench
13mm Wrench
14mm Wrench
19mm Wrench
Torque Specs:
Size Grade 5 Grade 8
5/16” 15 ft/lbs 20 ft/lbs
3/8” 30 ft/lbs 35 ft/lbs
7/16” 45 ft/lbs 60 ft/lbs
1/2” 65 ft/lbs 90 ft/lbs
9/16” 95 ft/lbs 130 ft/lbs
5/8” 135 ft/lbs 175 ft/lbs
3/4” 185 ft/lbs 280 ft/lbs
Class 8.8
Class 10.9
6MM
5 ft/lbs
9 ft/lbs
8MM 18ft/lbs
23
ft/lbs
10MM 32ft/lbs
45ft/lbs
12MM 55ft/lbs
75ft/lbs
14MM 85ft/lbs
120ft/lbs
16MM 130ft/lbs
165ft/lbs
18MM 170ft/lbs
240ft/lbs
1/2” Wrench
7/16” Wrench
3/4” Wrench
9/16” Wrench
Hammer
Floor jack
Jack stands
Pry bar
WD-40 or similar
penetrating oil
Flat Head Screwdriver
Thread Locker
Tools Needed:
