evenes EV-ZUP 15, Руководство пользователя

Страница: 15 / 26

EVENES CIRCULATING PUMP
EV-ZUP 15
29 EVENES CIRCULATING PUMP
EV-ZUP 15
28
EN
7 | ELECTRICAL CONNECTION
2.
4.
3.2
1.
3.1
4
7.1 Assembling the power plug
Connect the power cable to the pump as shown. Caution: Line voltage! Observe the
required protective measures, national body regulations and local provisions at all times. The
cable crosssection may be no smaller than 0.75 mm
2
. Use ferrules if using fine-wire cables.
8 | FILLING AND BLEEDING THE SYSTEM
Note:
The system must be thoroughly flushed before the pump is started up to prevent
contaminants or foreign bodies from remaining in the system. Fill and vent the
system correctly. To vent the pump, loosen the indicated screw by turning it anti-
clockwise.
Caution! Hot water may escape here, depending on the system‘s operating state.
Then tighten the union nut with 30 Nm torque.
Afterwards, you can start the pump in the desired mode. Incomplete venting can
lead to noises in the pump and system.
Warning! Risk of burns!
The entire pump can be very hot, depending on the operating
state of the system.