35
34
ADAPTERS
For the following valves no adapter is required:
Heimeier; Junkers Landy + Gyr; MNG; Honeywell; Braukmann, as
these have a thread of M30 x 1.5 mm. The adapters for Danfoss RAV
(pin must be plugged on the valve tappet) Danfoss RA and Danfoss
RAVL are included.
For the following valves you need an adapter:
Herz M28 x 1,5 mm; Comap M28 x 1,5 mm; Vaillant 30,5 mm; Oven-
trop M30 x 1,0 mm; Meges M38 x 1,5 mm; Ondal M38 x 1,5 mm;
Giacomini 22,6 mm; Rossweiner M33 x 2,0 mm; Markaryd
M28 x 1,0 mm; Ista M32 x 1,0 mm; Vama M28 x 1,0 mm; Pettinaroli
M28 x 1,5 mm; T+A M28 x 1,5 mm; Gampper 1/2/6
Exclude the Spirit Z-Wave Plus from the network before
removing. Set Z-Wave Controller in Exclusion mode. Hold the
boost button for at least 5 seconds to exclude. When this process
is finished,
INC
is again on the display. Unscrew the cap nut and
remove Spirit Z-Wave Plus off the valve.
REMOVING
If you are not sure which valve you have, please visit:
www.
eurotronic.org/Produkte/Adapter
Information. Here you
will find a list of various valves and adapters.
EN
EN
1.
2.
WARNING
Remove the connecting pieces of the plastic adapter com-
pletely before you use one of the supplied adapter!
INFO – Adapter
For additional adaptors, please visit:
www.eurotronic.org/shop
.
For information on the adapters, see the point adapter or see:
www.eurotronic.org/Service/FAQ
.
