Eurotherm Chessell 4102C, Руководство пользователя

Страница: 22 / 52

HA249928
Issue 15 Jly 06 Page 18
100 MM RECORDER USER GUIDE
rng
Lo
1
Hi
Lin
Unit
CJC
ECJ
resp
decp
rng
type
set channel
number
1
1
1
1
1
1
1
1
1
Select linearisation
function
Select ˚C or ˚F
Select CJC type
(Only for Type = TC)
If CJC type = external,
enter temp
Set break response
high, low or none
Set display decimal
point position
Type = TC or RTD
Lin = TC or RTD type
rng
Lo
1
Hi
Lin
SCLo
SCHi
Unit
Shun
1
Enter shunt value
(only for Type = mA )
decp
rng
type
set channel
number
1
1
1
1
1
1
1
1
Type = Volts / mV / mA / ohm
Lin = Linear or square root
Select linearisation
function
Enter scale low and
high values
Enter units text
string
Enter input range
low and high values
Set display decimal
point position
rng
Lo
1
Hi
Lin
Lo
Hi
Unit
Shun
decp
rng
type
set channel
number
1
1
1
1
1
1
1
1
1
Type = Volts / mV / mA / ohm
Lin = T/C or RTD
resp
1
Set break response
high, low or none
Select linearisation
function
Enter linearisation
range low and high
values
Select ˚C or ˚F
Enter shunt value
(only for Type = mA )
Set display decimal
point position
resp
Set break response
high, low or none
1
Enter input range
low and high values
Enter input range
low and high values
3.2.9 Range
Note: See section 4.4.3 instead, if the 'Channel tags' option is fitted.
This section allows the configuration of the input channels to be entered. Figure 3.2.9 shows the top level range con-
figuration menu for three cases:
1. Input type = thermocouple or RTD; Linearisation = TC or RTD type.
2. Input type = V, mV, mA or ohms; Linearisation type = linear or square root and
3. Input type = V, mV, mA or ohms; Linearisation function = Thermocouple or RTD type.
This last combination is used with transducer transmitters which do not incorporate their own linearisation tables.
Notes:
1. Channel one must not be used whilst configured as 'Ohm' or 'RTD' unless the CJ sensor has been disconnected
(
figure 2.2 ), or gross measurement errors will occur. When the CJ sensor disconnected, no other input channel
should be configured as T/C unless it uses an external CJC.
2. The background (PV) display will show 'brng' (bad range) if any one or more of the following obtain:
a.
Input range low
≥
Input range high
b. Linearisation range low
≥
Linearisation range high
c. Scale low = Scale high
d. Hardware capabilities are exceeded
e. Linearisation type is inappropriate to the rest of the configuration
Figure 3.2.9 Channel range configuration menu