EUROTECNO S.R.L Maior Omnia, Руководство по инструкции, использованию и обслуживанию, Страница: 32 / 50

EN
3 - INSTALLATION
THIS MANUAL IS PROPERTY OF EUROTECNO S.R.L.
– REPRODUCTION, EVEN PARTIAL, IS FORBIDDEN.
3 - 16
3.7. DEMOLITION AND DISPOSAL
With reference to demolition and waste disposal, note that the constituent parts of the machine are not made
of dangerous materials and they largely consist of:
-
ferritic steel;
- stainless steel;
- actuators;
- resins;
- electrical wiring with relative sheaths.
After dismantling the equipment, it is necessary to sort the various materials as per the standards in force in
the country where the equipment is to be disposed.
The equipment does not contain dangerous components or substances that require special removal
procedures.
WARNING:
To ensure a proper environmental protection, remove and dispose all the materials obtained
from the equipment demolition in compliance with the relative standards and regulations.
3.7.1 Dismantling procedure
Should it be necessary to disassemble the Maior Omnia® in order to carry out its demolition, proceed as
follows:
•
Check the environmental protection laws, in force where the equipment is in use.
•
Group the components together according to their chemical nature.
•
Proceed with the disposal as per the laws in force where the equipment is in use.
•
During this process, observe all the rules and instructions regarding workers safety.
WARNING:
The dismantling operations must be carried out by qualified personnel.
WARNING:
The laws vary from country to country; it is therefore necessary to comply with the regulations
imposed by the laws and the relevant authorities in the country where demolition takes place.