Stainless Steel Tumbler
To clean the stainless steel tumbler, use a damp
cloth with a mild, non-abrasive cleaner suitable
for stainless steel surfaces.
Remove the cleaner residue and dry with a clean cloth.
Clean periodically the interior part
of the door to remove any fluff.
Accurate cleaning ensures correct
drying.
Dryer Exterior
The enter dryer has a high-gloss finish. Clean with a soft, damp cloth. Don’t use abrasive substances.
Protect the surface from sharp objects as they may scratch or damage the finish.
Don’t place any heavy or sharp objects or a detergent box on the dryer. Keep them on the purchased
pedestal or in a separate storage box.
Open the loading door.
Remove the lint filter by putting it up and open the lint filter.
Clean lint, fibre, and cotton raveling by hand or with a soft piece of cloth.
Close the lint filter and place it back into its housing.
A layer can build up on the filter pores that can cause clogging of the filter after
using the dryer for a while. Wash the lint filter with warm water to remove the
layer that builds up on the lint filter surface. Dry the lint filter completely before
reinstalling it.The lint trap has to be cleaned frequently.
Always clean the lint filter and the inner surfaces
of the loading door after each drying process.
Filter case
Clean with a soft, damp clothes. Do not use abrasive substances.
Don’t spray cleaners directly on the panel.
The control panel finish may be damaged by some laundry pre-treatment soil and stain remover products.
Apply such products away from your dryer and wipe up any spills or overspray immediately.
When cleaning the product, be sure to unplug the power cord.
Durning the drying cycle, the control panel or the door may accumulate moisture.
Water-tank
Water container collects all of the water from condenser.
Water container need to be emptied after every drying
cycle. If the water container is full, an active programme
will break off automatically. the light will comes on
and the buzzer sounds. In order to continue the
programme, the water container must first be emptied.
Water container emptied
1.Pull out water container
3.Pull the water container
in dryer
2.Tip water into pool
4.Press the Start/Pause
button
Humidty sensor
In the movement process, this device is used for induction clothing humidity, it means
that it must be carried on cleaning. Major cause of clean is must scour out the calcium
oxide boiler which on the sensor surface up. Clean the sensor in the tumbler (See picture).
10
