All drying programmes end with 10 minutes cooling phase. If the laundry is not removed at the end of
the cycle, the dryer runs anti crease phase (default: 30 minutes, select: 120 minutes).
If you do not remove the laundry, the dryer will stop automatically at the end of the anti crease phase.
The display shows “End” and the buzzer sounds for 15 seconds when the buzzer function is on.
To finish,turn the programme selector dial to off.
When the machine is on, press meantime “Time” and “Dry level” button
the system will
lock all the buttons. Then all buttons are invalid except “off ”. If you want to make the appliance to return to
the normal state ,then press “Time” and “Dry level” button for several seconds meantime again.
The function will be released in the following cases:
Open the door during operation
Take out filter drawer during operation
Water tank full
You can set again the “Child Lock” function when you restart the machine.
for several seconds,
Child Lock light
This light indicated the appliance is locked.
Buzzer light
This light is on when buzzer programme is selected.
Delay Start light
This light is on when delay start programme is selected.
Drying Type light
these lights will be on when Dry Level function is selected.
When you choose different drying intensities, the corresponding indicator light turns on.
Tank full light
It comes on after each program and also when the water tank is full. which
remind you to empty the water container.
Note! Empty the water container after each program to avoid the alarm when use in next time.
Important!
program selector dial to position “Refresh” and wait until the end of this cooling phase before removing
the laundry.
This will avoid a build-up of heat inside the appliance.
To do this first turn the dial to “off ” and then to “Refresh” and depress the“Start” button.
Modifying the program
To change a program which is running, first cancel it by turning the programme selector dial to “off ”.
Select the new program and press the “Start” button.
Attention:
According to "-" for the dormant state;
- standby mode, 10 minutes later, without any operation, enter a dormant state.
- controller shows "End", 10 minutes later ,without any operation, enter a dormant state.
If the drying program has to be stopped before it reaches the end , we recommend that you turn the
7
