EUROPRO 30893, Руководство пользователя

Страница: 14 / 20

User manual - HYDROPRO 600 201706-229-ENG P14
The direct projection of water under pressure onto the motor has to be stopped at
the risk of water infiltration. Proceed by simply cleaning with a humid sponge.
6. CLEANING PROCEDURE
1. Remove the suction rod (A) from the bucket of product.
2.
Place instead a bucket of water and replace the suction rod.
3. Open the valve (B) and atomize the water to clean the produict circuit and evacuate the paint
remaining into the hose.
4. Open the drain valve (I) and let the water flow out of the (J) hose.
5. Remove the product filter (C) of its housing to verify it is cleaned well.
6. Put the switch (H) onto the "OFF" position, then disconnect the machine of the electrical network.
* if thermal motor, put the (N) button onto the "OFF" position.
After utilization, to avoid a too quick decompression of the pump, close the valve
(B). Then press the spray-gun trigger and let the pressure flow out.
Release the trigger and open the valve (B).