EUROPRO 30893, Руководство пользователя

Страница: 13 / 20

201706-229-ENG User manual - HYDROPRO 600 P13
5. USE OF THE MACHINE (continued)
Before each utilization, use the gauge (F) to verify the oil level. If needed, fill with
hydraulic oil.
5.2. STARTING UP - ELECTRICAL MOTOR
1. Plug in the machine.
2. Dive the suction rod (A) into the bucket of product.
3. Make sure that the valve (B) is closed to avoid the pressure raising too fast.
4.
Put the switch (H) onto the "ON" position to start the machine.
5. Let the machine run a few seconds, then open the valve (B), the machine is ready to be used.
6. During utilization, use the (G) thumbwheel to increase or decrease the working pressure.
7. In case of change of the product bucket, close the valve (B) before removing the suction rod from
the bucket.
5.3. STARTING UP - THERMAL MOTOR
1. Open the fuel valve (L).
2. Put the starter (K).
3.
Turn the (L) motor switch to the "ON" position.
4. Dive the suction rod (A) into the bucket of product.
5. Make sure that the valve (B) is closed to avoid the pressure raising too fast.
6. Position the accelerator lever (P) to the middle.
7. Pull the launcher (M) to start the machine.
8.
After a few seconds, remove the starter.
9. Let the machine run a few seconds, then open the valve (B), the machine is ready to be used.
10. During utilization, use the (G) thumbwheel to increase or decrease the working pressure.
11. In case of change of the product bucket, close the valve (B) before removing the suction rod from
the bucket.