18
Slide a new brush over the spindle with the
protrusions on the spindle in the recesses on
the brush hole (first remove the old brush if it is
to be replaced).
Do up the tensioning screw again while holding
the spindle still.
The hard brush supplied is suitable for regular
and stubborn weeds.
A worn brush must be replaced immediately.
USER INSTRUCTIONS
Before use:
Check that the wheel, brush and the closure on the shaft are secure.
Check that the socket you are using provides
the correct voltage (see specification plate on
weed brush).
Connect the weed brush to a suitable extension
cable and hook the cable behind the clamp (see
diagram).
Hold the device with both hands (one hand on
each handle) and check that the underside of
the device is flat and horizontal.
Operating:
If all checks are ok, you can put the plug into the
socket.
Now press the unlocking device (A), press the
ON/OFF switch (B) and keep it depressed.
Release the ON/OFF switch in order to switch
the device off. The device will lock automatically.
Use:
Move the device over the surface area to be treated at a constant speed. For the best
results, you are advised to test the device on a small area first. Check to ensure the tiles
are not damaged.
Only use the device for dry weeds.
Keep the device out of the vicinity of hard objects and plants.
Brush the long edges first and then the short ones.
Do not use the brush in the same spot for too long. The brush will then push into the
joints and will remove the sand/soil.
Regular brushing helps prevent stubborn weeds taking hold.
