
17
ELECTRICAL SAFETY
Before use, always check to ensure that the socket you wish to use provides the
Voltage and Hertz detailed on the
weed brush’s specification plate.
Connect the weed brush to an electrical group that is protected by an earth leakage
circuit breaker of max. 30 mA.
Only use approved extension cables of sufficient capacity.
DESCRIPTION
Your weed brush has been designed to remove
weeds from between tiles and on patios.
1. Unlocking
2. ON/OFF switch and handle
3. Steering handle
4. Shaft
5. Protection cover
6. Brush
7. Wheel
ASSEMBLY
Before carrying out any assembly work: make sure that you remove the plug from
the socket!
Assembly of shaft
Push the upper shaft into the lower shaft as far
as it will go (there is only one way to do so).
Make sure that the electrical cable is not
pinched!
Screw both parts together using the 2 screws
on the sides.
Assembly of protective cover
Mount the protective cover (5) on the device, as
shown in the drawing.
Secure the protective cover with the screws.
Replace the cover when it gets worn.
Assembly of brush
Use the Allan keys supplied and wear protective
gloves.
Undo the tensioning screw while you hold the spindle still, see drawing.