EuroLite DYNAMIC FOG 2000, Руководство пользователя

Страница: 24 / 28

www.eurolite.de
24
DMX512 Operation
For operation with a controller with DMX512 protocol, the fog machine is equipped with 1 control channel. To
be able to operate the machine with a DMX controller, it must be adjusted to the address provided for it on
the controller via the menu. The DMX channel ranges between the values 0 to 255 and controls the fog
output volume.
DMX value Function
0 – 5 no fog output
6 – 249 minimum fog output (5 %)
high fog output (95 %)
250 – 255 maximum fog output (100 %)
Fluid Sensor
To protect the pump and the heater, the machine uses a fluid sensor to test if there is smoke fluid in the
tube. You can check the fluid level visually by means of the fluid level indication on the side panel. Always
refill with fluid, when the fluid level becomes low to continue using the machine. The fluid sensor control can
be turned off in the menu. However, it is a very important protection mechanism and should remain activated
for proper operation.
Notes Regarding Operation
1
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when
installing your unit.
2
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
after being turned off.
3
All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
4
If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check
the fluid level, the external fuse, remote control connection and the power supply. If all of the above
appears to be ok, reconnect the unit again. If fog does not come out after holding the
MANUAL button
on the remote control for 30 seconds (make sure the fog output volume is adjusted with the control
OUTPUT ), check the tube attached to the tank to make sure there is fluid going through it. If you are
unable to determine the cause of the problem, do not simply continue pushing the remote button, as
this may damage the unit. Return the machine to your dealer.