EuroGames MINICAR, Справочник по эксплуатации и техническому обслуживанию

Страница: 26 / 32

Eurogames Srl – Operation and maintenance handbook – Mini Car
26
To recharge the batteries of the “Minicar” series Automatic Games, operate as it follows:
•
Act on selector (E) in relation to battery type to be recharged:
Lead Acid or AGM / Sealed / Gel
ATTENTION
DO NOT RECHARGE the hermetic AMG/GEL batteries with the switch set to the LEAD ACID
function as they could be damaged.
•
Plug in the battery charger to the low voltage mains (220 V).
•
Connect the battery charger cable to the Automatic Game (Fig.19) using the special safety connector
against polarity inversion.
•
The battery charger condition is signaled by the on/off turning of the colored warning lights on the front
panel, and namely:
Pos. Reference Signal Meaning
A Ready Yellow blinking Battery disconnected - standby mode
B Charging Red on Battery charge
C End Charge Green blinking End of charge
C
End Charge Green on Battery charged
D Error Red blinking Error condition
•
The battery charger enters the error mode:
- when the battery is dead;
- when the poles have been wrongly connected;
- when the battery voltage is other than the one required;
- when the battery is damaged;
- in the case of overheating of the battery charger
In such cases, refer to the instructions in the battery charger manual.
•
After the recharge, and if you have not to recharge any other Automatic Game, disconnect the battery
charger from the vehicle and from the mains and store it suitably.
Safety
ATTENTION
•
The battery should not be dip in water or placed closed to wet parts.
•
Disconnect the power cord before displacing the battery charger.
•
Ensure the power cord of the battery charger is steadily protected and not damaged.
•
Plug the battery charger only after having checked the mains voltage is that given in the plate
located on the battery charger external casing.
•
Do not connect the battery charger to industrial mains. This connection could alter the
compliance with the uniform standards on electromagnetic compatibility; as a consequence it
could result in electromagnetic troubles, and cause similar troubles which could jeopardize the
functioning of other appliances. Before plugging, ensure the power socket is protected by a
thermal switch, with an amperage corresponding to that given on the plate located on the battery
charger, and by a differential switch with suitable cutoff power and sensitivity. Do not connect
more battery chargers downstream the same thermal switch. The installation and use condition
of the battery charger must be checked at least every 15 days and after any long inactivity period.
•
Periodically check the condition of the cable and of the power plug, and the efficiency of the
differential protection of the battery charger (every 15 days).
•
The battery charger should not be tampered or modified by the user. The EuroGames products
meet the established standards. Repairs works should be carried out only by specialized and
authorized technicians. Any repair work carried out by non qualified or authorized people could
result in accidents or damages to the users. Before any intervention, ensure the switch upstream
the plug connecting the battery charger to the power supply line is switched off.
•
Do not lay loads on the power cord. Keep off the power cord.
•
Do not cover the battery charger when functioning; do not close the ventilation grilles of the
plate casing.