EuroGames MINICAR, Справочник по эксплуатации и техническому обслуживанию

Страница: 24 / 32

Eurogames Srl – Operation and maintenance handbook – Mini Car
24
Display description
In the display there are some useful information: The internal software
version, “BAT=” battery charge value, “Device Selected:” Selected
product for next command transmission, “LastCommand=” last sent
command information.
EG09 Digital Timer Configuration – “ALL” devices
To setup all the device together the “ALL” option must be selected. Press
[PROG] button to enable the programming mode. The display shown the configuration parameters. The
[+] and [-] buttons select the required parameter and the [SEL] button enable the editing mode. In the
editing mode a black blinking cursor is shown. The value can be changed by [+] and [-] buttons.
The new value is sent to the device when the [SEL] button is pressed again to exit editing mode. Please
note that all the powered products in the transmission range will receive the new parameter
configuration.
Below you can find an example list of parameters that can be changed by the remote control unit when
“ALL” option is selected. Important: the available parameters may be different due to a possible
software update without notice (for more information please check the EG09 Digital Timer
Configuration).
Game-Time, Game-Coins, Coin-Mode, Volume, Speed-High, Speed-Low, Auto-Brake, End-Brake,
EndBrakeDelay, TelBrakeDelay, End-Sensor, EndSensTime, Accelleration, Deceleration, Low-Battery,
Free Coins, Max Speed, EndGame Stop.
EG09 Digital Timer Configuration – Single device
To setup a single device its specific number must be selected as “Device
Selected” option. Press [PROG] button to enable the programming
mode. In this case the remote control unit receive the configuration
parameter value directly from the selected EG09 Digital Timer included
in the product. In the “Single” configuration mode all the configuration
parameters included in the EG09 Digital Timer can be changed.
The [+] and [-] buttons select the required parameter and the [SEL] button enable the editing mode. In
the editing mode a black blinking cursor is shown. The value can be changed by [+] and [-] buttons. The
new value is sent immediately to the device. Press [SEL] button to exit editing mode.
If the remote control unit detect no transmission message from the device a “* No Signal *” message is
shown in the display. In this case check the power and the device number.
Batteries
The remote control unit is powered by 2 common AA 1.5V batteries. The replacement of the batteries is
easy trough a small batteries cover placed in the bottom part of the case.
IMPORTANT
During replacement please take care of the battery polarity direction. Wrong position can damage the
remote control. To avoid problems with a possible acid leakage remove batteries if the remote control
unit will be stored unused for a long time.
Do not connect any power supply unit to the remote control unit connectors to avoid damages.