Euroboor B60, Руководство оператора

Страница: 33 / 48

33
5.3 Bevelling pipe material
Make sure the machine is converted for use on pipe material as described in paragraph 3.7
The standard guide plate assembly allows EUROBOOR B60(S) to be used for bevelling pipes with
outer diameter ranging from 150 to 300 mm.
1. Set the depth adjustment to 0
2. Position the machine above the pipe opening
3. Slightly loosen both guide roller assembly bolts (see paragraph 3.7), allowing the rectangular
slide nuts to move in the designated slots.
[image 3-3]
4. Symmetrically move the guide rollers to touch the pipe, and tighten the bolts again.
[image 3-4]
5. Prepare the machine as described in chapter 3
Angle adjustment:
Angle adjustment should be between 1 and 60 degrees.
Depth adjustment:
It is strongly advised to have the depth adjustment not deeper than (additional) 6 mm per
pass. For example, if you want to create a bevel width of 15 mm:
First setting: 6 mm
Second setting: 12 mm
Third setting: 15 mm
6. Position the machine vertically on the right (not left) side of the intended bevel.