Euroboor B60, Руководство оператора

Страница: 36 / 48

36
6. Maintenance
Your EUROBOOR power tool has been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and
regular cleaning.
CAUTION!: To reduce the risk of injury, turn unit off and disconnect machine from power
source before installing and removing accessories, before adjusting or changing set- ups or
when making repairs.
Be sure the switch is in the OFF position. An accidental start-up can cause injury.
Just as every power tool with moving parts, your EUROBOOR B60(S) also needs regular maintenance.
VISUALLY CHECK THE MACHINE FOR DAMAGE
Machine must be checked before operation for any signs of damage that will affect the operation of
the machine. Particular notice must be taken of the mains cable, switches and moving parts. If the
machine appears to be damaged it should not be used failure to do so may cause injury or death.
CLEANING
- Clean all dirt, dust, metal chips and burrs from the machine regularly. Special attention is
needed for the milling head and its surroundings, as well as the heat sink ribs underneath the
electronics housing (on top of the motor). The use of compressed air is advised. Never remove
metal chips with bare hands!
- Blow dirt and dust out of the motor housing with compressed air as often as dirt is seen
collecting in and around the air vents. Wear approved eye protection and an approved dust
mask.
- Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool.
These chemicals may weaken the materials used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool
into a liquid.
PRESERVATION
Moving parts, such as the guide rollers, should regularly be lubricated using a very thin layer of
general machine oil. Light lubrication also works as rust prevention when the machine is put out of
use for a certain period.
OPERATION OF THE MACHINE
The machines operation must be checked to ensure that all components are working correctly.
Replace any defective parts immediately. This prevents properly function parts from being damaged.
REPAIR, MODIFICATION AND INSPECTION
Repair, modification and inspection of EUROBOOR B60(S) must be done by EUROBOOR or an
EUROBOOR authorized dealer. The spare parts list will be helpful if presented with the machine to
the Euroboor dealer for service when requesting repair or other maintenance.
Euroboor machines are constantly being improved and modified to incorporate the latest
technological advancements. Accordingly, some parts (i.e. part numbers and/or design) may be