Eureka 4880 Series, Руководство пользователя

Страница: 10 / 20

10
1
2
NOTE: Turn off the switch and unplug the electrical cord
before replacing belt. Belt pulleys can become hot
during normal use. To prevent injury, avoid
touching the motor shaft when checking the belt.
1. Move brush roll control lever to hard floor position.
3. Remove brush roll. Discard broken or damaged belt. Place
new belt around motor shaft and brush roll. Avoid touching
motor shaft, it may be hot.
NOTE: The new belt will appear to be too large. This is
normal.
3
4
HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust
cup, filters, belt, and brush roll often.
Brush Roll
The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt
The brush roll belt turns the brush roll to agitate, sweep, and comb the carpet nap. Check the belt regularly to be sure it is
in good condition and rotating the brush roll. Replace the belt if it cracks or tears. Cut away any hair or threads wound
around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
NOTE: Belt breakage may occur as a result of brush roll stall.
2. Remove 3 base plate screws using a Phillips® #2 head
screwdriver. Lift base plate off base.
4. Insert left end (pulley end) of brush roll into base.
Motor
Shaft
Brush
Roll
Pulley
How To Replace Brush Roll Belt,
Part No. 61110