Euphonix MixView CS2000, Руководство по эксплуатации

Страница: 73 / 324

Section 4: Tutorial
Euphonix CS3000/2000 Operation Manual 4 - 3
SECTION 4 : TUTORIAL
∑
Bus
Summing
Amp
Combiner
∑
Signal Flow
Diagram Symbols
Direct Out
Line Input
Aux B
Aux A
AUX BUS
1 - 8
4 Band EQ
LF
Line Out
PWR
P
lease read Section 2 before proceeding with the Tutorial so that you can
store and recall the routing setups you construct. You will need an audio
source to route through the patchbay; it can be a CD player, DAT machine, or
even a tone generator. We will begin by introducing the functional components
of the audio path. In the first exercise, we’ll route audio signals from the
patchbay to the stereo bus and then to the monitors.
Each channel strip has a number of audio elements that, depending on your
routing setup, can form two completely separate mono or stereo signal paths.
The SnapShot Recall system will save a particular signal path routing for
instant recall making console setup simple, quick, and flexible.
The symbols below represent the elements within the channel strip.
2 Universal Input Amps (UIA) - Will accept both microphone and line levels
and impedances. Variable gain control. Designated M1 & M2. M2 has the
option of bus/tape switching. M1 can be fed by the Combiner.
4 Line Inputs - Fixed at unity gain, for line level (+4dBu) signals. Designated
L1, L2, L3, & L4. L4 has the option of bus/tape switching.
4 Aux Send controls - 2 blocks each with 2 sends feeding 8 buses. They are
source-assignable from any of the channel strip’s 6 inputs. They can be pre/
post, upper or lower fader as well as completely separate from the fader path.
2 EQs, 4-band parametric - Assignment of the EQs can be 1 per fader (1
upper and 1 lower), linked and assigned to a stereo fader (upper or lower), or
cascaded to produce an 8-band parametric EQ, and assigned to a fader (upper
or lower). EQs are assigned to the signal path via source input assignments.
2 Long-Throw (100 mm) Automated Faders - Each has pan/balance and
mute.
3 Line Outputs - Designated Out1, Out2, and Out3 (pre-fader).
2 Direct Outputs - Designated Dir1 & Dir2. They can be sourced from the bus
summing amp, combiner, or post-fader signals. Assignable as 1 stereo or 2
mono. Dir2 has 2 parallel feeds available from the patchbay.
1 Combiner - This is a 6-into-1, unity-gain mixer.
1 Bus Summing Amp - Takes the multitrack bus associated with that channel
and amplifies it to line level.
Busing - Each channel strip can access 2 sets of Stereo buses, 24 Multitrack
buses, 8 Aux send buses, Stereo Solo (PFL/AFL) bus.