©2016 ETS Corporation |
iSC250 Installation and Configuration Guide
17
This information is CONFIDENTIAL and must be used exclusively for the operation of ETS software, hardware, or services. It
may not be duplicated, published, or disclosed without the express permission of ETS.
2.2 Configuring the iSC250 for USB-Serial Mode (USB Enabled
Terminals with Included USB Cable)
Table 4:
Ingenico ISC250 USB Mode
Configuration Steps
Step
Number
ISC-250
Screen View
Step Instructions
1
a.
Reboot the iSC250
b.
Hold the
[-]
and [
Clear
(Yellow)]
buttons until the device makes a
beep tone and then release the
buttons.
2
Wait for the Telium Operating System to
complete the boot sequence.
(No operator actions are required during
this step)
