H. Rubber Sealing Strip
I.
Sealing Gaskets (up and down)
J. Vacuum Chamber
K. Sealing Wire / Heater
L. Cutter
HOW TO USE THE BAG CUTTER
In the back of the appliance is the bag cutter. This accessory easily lets you get an even and
neat cut. Frayed, lopsided, or crooked edges could prevent the generation of a vacuum and
interfere with the sealing process.
1.
Open the cutter bar. To do this, push the black handles at both sides of the cutter
bar to the rear of the appliance.
2. Insert the bag between cutter bar and the base of the appliance. Then press the
cutter bar in place again, until it clicks shut.
3. Push the slider of the cutting bar to the opposite end of the cutter bar.
4. Pull the bag out from under the cutter bar.
HOW TO MAKE CUSTOM SIZED BAGS
1.
Pull enough bag material to hold the item being vacuum packaged, plus 50mm. With
the cutter, cut the desired bag length from bag roll. Make sure to cut it in a straight
line. Plug in the power cord.
2. Open lid. Place one end of cut bag onto sealing strip, don’t worry if you accidentally
place any material onto the gasket area.
3. Close the lid by touching down firmly on both sides, check to make sure that the lid
will not open. If you hear a “click” on each side, then you have successfully locked the
lid in place.
NOTE:
The sealing strip will NOT work properly unless you lock the lid. Make sure that
the lid has been locked on both sides for proper sealing.
