5
!
several minutes after switching off.
DO NOT
switch off at temperatures
above 100 °C. Allow to cool before storage.
Care must be taken when removing probes and inserts from the
unit. If the unit is set at a high temperature the inserts will be very
hot and could cause burns to the hands. Please use the insert removal
tool supplied. After removal place hot probes and inserts only on a
suitable heat proof surface.
Only place inserts and temperature probes in dry-well holes. This unit
is designed to be operated dry.
DO NOT
introduce any liquid into any
of the dry-well holes.
These dry-wells are designed to be rugged and durable but contain
electronics.
DO NOT
operate in dirty, dusty or very damp environments
or near liquids that could present a hazard from electric shock.
The power supply with this instrument should be connected to grounded
AC power supply (100 - 240VAC 50/60Hz). The unit requires ≤160
watts of power. Mains plug fuse rating is 3 amps.
The 3101 dry-well heat source is programmed and calibrated at the
factory for optimum performance and should not need adjusting. If
the unit is out of calibration or is in need of repair please return to the
supplier. The dry-well is equipped with an internal electrical fuse. If a
fuse blows, return to the supplier for inspection and repair. THERE ARE
NO USER SERVICEABLE PARTS INSIDE.
PARTS AND CONTROLS
POWER SUPPLY
The power supply for this instrument should be connected to grounded
AC power supply (100 - 240VAC 50/60Hz). The output of the power
supply is 12VDC 8.5A (102W).
POWER SWITCH
The power switch is located on the rear panel of the unit and operation is
indicated with a 1 and a 0. DO NOT introduce any liquid into any part of
the instrument.
FAN
The internal fan runs continuously when the unit is operating. This
provides cooling for the internal electronic components and the heatsink.
Содержание 271-401
Страница 1: ...3101 Dry Well heat cool source calibrator User Manual order code 271 401...
Страница 2: ...2...
