Add:
To add an IP QoS session, place a check at the Enable IPQoS then click
Add
button. The
following screen will pop-up.
Rule Name:
Enter the IP QoS session name.
Source IP
: Enter the Source IP Address.
Source Netmask
: Enter the Source IP Subnet Mask.
Source Start Port
: Enter the Source IP Start Port which PPP session can be activated.
Source End Port
: Enter the Source IP End Port which PPP session can be activated.
Destination IP
: Enter the Destination IP Address.
Destination Netmask
: Enter the Destination IP Subnet Mask.
Destination Start Port
: Enter the Destination IP Start Port which PPP session can be activated.
Destination End Port
: Enter the Destination IP End Port which PPP session can be activated.
Protocol
: Select the protocol from the drop down manual. The protocols supported are TCP, UDP,
ICMP and ANY.
Physical Port
: Select the QoS Physical Port from the drop down manual.
Traffic Priority
: Click and select the QoS session Traffic Priority from the drop down manual.
TOS Marking
: Place a check at the Normal Service or select the TOS Marking from the list.
Apply:
Click the Apply button to confirm your setting.
Cancel
: Click Cancel to ignore all the changes.
Save All:
To complete and save the setting, click
Save All
after clicking the
Apply
button.
4 Ports ADSL2/2+ Router
67
