ETC Source Four PAR EA, Инструкция по сборке

Страница: 7 / 12

Housing Assembly 5
Assemble housing
Tools Required:
• Minimally padded work surface (cardboard, carpet, or rubber mat recommended)
• Phillips screwdriver
Step 1: Install the reflector mount silicon pads (7) in the left barrel assembly (6). Install
the pads in two places on both sides. See Figure 4 .
Step 2: Install the lens stop (9) and rotator spring clip (2) into the lens rotator (8). Install
the lens rotator into the left barrel (5).
Step 3: Install the rotator pressure clip (6) into the left barrel (5) and attach using screw
(12).
Step 4: Install the gel retainer clip (1) and the spring retainer (14) into the right barrel (4).
Step 5: Install the reflector (3) into the left barrel (5). Align the rib on the reflector with the
left barrel pocket as shown in Figure 5 .
Step 6: Attach the right barrel (4) to the left barrel (5) using three screws (11). Hand
tighten only (25 in. lbs.).
Step 7: Clean reflector. See “Cleaning the reflector” on page 6.
Step 8: Check for ease of movement of the gel clip retainer (1). The clip should latch into
the left barrel in the down position and be free of binding.
Step 9: Check for smooth rotation of the lens rotator (8).
Step 10: Snap the focus knob plug (13) into the bottom of the fixture.
Step 11: Attach label (10) onto the left barrel as shown in
Figure 5 .
W A R N I N G :
This procedure may crack or break the reflector. Always wear gloves, safety
glasses, and a dust mask when performing this procedure.
ALIGN RO
TA
TOR CLIP
ALIGN Z
OOM LENS
C T E
Source Four PAR
Figure 5
Left barrel alignment arrow
Label (10) alignment
Align rotator spring clip (2) on rotator
with rotator tab on left barrel (6)
Align rib on reflector (8) with left barrel (6) pocket