ETC Source Four PAR EA, Инструкция по сборке

Страница: 5 / 12

Lamp Socket Assembly 3
Assemble lamp socket
Tools Required:
• #2 Phillips screwdriver
Step 1: Install the ground wire (6) and the TP22 assembly (9) in the sleeving (10). See
Figure 3 .
Step 2: Snap the focus handle (5) onto the burner (3). See Figure 2 .
Step 3: Secure the ground wire lug (6) onto the burner casting (3) using screw (7).
Step 4: Place the TP22 assembly (9) into the burner casting (3). See Figure 3 .
Step 5: Insert the screws (8) into the four positions in the strain relief casting (4). See
Figure 3 .
Step 6: Position the sleeving assembly (10) as shown in Figure 3 . Fold the sleeving so it
fits cleanly in the slot between the burner and the strain relief.
Step 7: Place the strain relief (4) on the burner casting (3). Loosely attach the screws (8).
The TP22 assembly (9) must be centered in the strain relief opening (4). See
Figure 3 .
Step 8: To guard against stripping the screws, tighten them in the order shown in
Figure 3 .
Step 9: Make sure the focus handle is secure, then insert the knurled head screw (1)
through the handle (5) into the burner casting (3). Tighten securely.
N o t e :
Position the wires with the green ground wire on top of the two TP22 white leads.
Make sure the green ground wire is not touching any part of the burner casting.
Figure 3
TP22
assembly (9)
Knurled head
screw hole
Sleeving (10)
Ground wire (6)
and 6-32 x 1/4
screw (7)
Strain relief
casting (4,)
Burner casting
(3)
Tighten 2
Tighten 1
Tighten 3
Tighten 4