19
BluesSystem Installation Manual
Terminate 0-10 VDC Wiring
For Sink Control
Step 1:
Insert the wire from one side of the 0-10 VDC controller into the +10V terminal on the
BluesSystem power supply and tighten the screw firmly onto the wire.
Step 2:
Insert the wire from the other side of the 0-10 VDC controller into the CH.1 terminal on
the BlueSystem power supply and tighten the screw firmly onto the wire.
Step 3:
Repeat Steps 1 and 2 for all 0-10 VDC connections
Step 4:
Set all corresponding dip switches to Sink.
For Source Control
Step 1:
Insert the wire from one side of the 0-10 VDC controller into the COM terminal on the
BluesSystem power supply and tighten the screw firmly onto the wire.
Step 2:
Insert the wire from the other side of the 0-10 VDC controller into the CH.1 terminal on
the BluesSystem power supply and tighten the screw firmly onto the wire.
Step 3:
Repeat Steps 1 and 2 for all 0-10 VDC connections
Step 4:
Set all corresponding dip switches to Source.
CAUTION:
Control wires are polarity dependent. Crossing the + and – wires while
combining drivers will result in improper performance.
Note:
Sink control refers to control voltage being provided by the BluesSystem Power
Supply to the 0-10VDC controller to set the light output.
Note:
Source control refers to control voltage being sent from the 0-10 VDC controller to
the BluesSystem Power Supply to set the light output.