ETC ARCP1, Руководство по установке

Страница: 15 / 64

System Overview 9
TX1 Transmitter
The TX1 Transmitter is the DMX wireless gateway for the ArcMesh
protocol.
One transmitter:
•
Controls up to 100 devices across 64 DMX addresses.
•
Has a 24 preset scene memory.
•
Has DMX wired output for control of third party equipment
within scene store.
•
Has two auxiliary inputs for closed contact connection to
trigger a stored scene.
Each transmitter can be set to one of 16 available network IDs
allowing multiple transmitters to be used concurrently without
“cross-talk.” When two or more transmitters are set to the same
network ID and radio channel, the transmitter with the highest
MAC address acts as a master with the others assuming the role of
backup.
For information on system installation, see
TX1 Installation on
page 47 .
ArcMesh
ArcSystem products can be controlled using wired DMX through RJ45 connections, or the
wireless ArcMesh protocol. A wireless installation is an ideal solution for retrofit situations where
installing additional cable is not practical.
The following diagram illustrates a basic hybrid ArcSystem installation with a wireless luminaire,
TX1 Transmitter, and a wired DMX console for the main control source.
AC Power
100-240 VAC
Active DMX
output for other
wired devices
DMX512 from
Lighting Control
AUX Input Toggle
Operation
DMX out DMX in
Wireless Luminaire
TX1 Transmitter
Each system requires a minimum of one TX1 Transmitter. The TX1 is used as a transmitter of
wireless data to luminaires or other devices within a system.
Note:
By default the TX1 DMX output is disabled. If you require DMX output from the
TX1, you must use the ArcSystem comissioning tool software to add DMX fixtures.