the front by slight pushing. You will hear a clicking sound. Check proper fastening
of the front by slight pulling of the dust filter. Slide the adapter with a filter to the
holder in the suction space and push it to the maximum position.
Close the vacuum cleaner lid by snapping it shut. You will hear a clicking sound.
Replacing micro–filters
After replacing about 5 dust filters, micro–filters must be cleaned or replaced with new ones.
Dispose of the used dust filter and the micro–filters with common municipal waste. You can
buy replacement filters and micro–filters in electro store chain.
Suction micro–filter
Take out grid
A8
with filter
A16
by pulling it upwards (Fig. 16). Remove the filter from the
grid (Fig. 17) and clean it in running lukewarm water, e.g. using a cloth or a soft brush and
let it dry completely (Fig. 19). After drying, put the grid with a new micro–filter in the opposite
direction behind the guide ribs and slide it to the suction area of the vacuum cleaner to the
maximum position.
ATTENTION
–
The „UniBag” dust filter is not intended for repeated use.
– DO NOT THROW THE ADAPTER AWAY!
– Do not use any aggressive washing or cleaning agents or hot water to clean the HEPA
filter and the micro–filter.
– Cleaning the filter will not restore its original colour, but it will restore its filtration properties.
– The HEPA filter and the micro–filters are not intended for cleaning in a dishwasher.
– Proper insertion of the dust filter to the holder will secure the mechanical safety lock.
Now you can close the lid of the vacuum cleaner
– Neglecting regular replacement of micro–filters can result in the vacuum cleaner failure!
– Make sure that the contact surfaces and sealing elements are functional.
– We recommend replacing the HEPA filter twice a year. Replace the other micro–filters
if they cannot be cleaned properly or if they are damaged. You can buy a replacement
dust filter, a HEPA filter and a micro–filter in the elektro shop chain.
Exhaust micro–filter
Lift off vacuum cleaner lid
A3
by pushing lock
A2
to the locked position (Fig. 13). Exhaust
HEPA filter
A13
from the vakuum cleaner (Fig. 18). Tap the dust out of the filter over a
dustbin or to clean the filter through a blowing (we recommend the filter cleaning outside of
living area for hygiene reasons). If the protection micro filter is very dirty, you can also rinse
the pleated side of the HEPA filter under lukewarm slow-running tap. Hold the filter in such a
way that the pleated side points upwards and the water flows parallel to the pleats. Hold the
filter at an angle so that the water washes away the dirt inside the pleats. Turn the filter 180°
and let the water flow along the pleats in the opposite direction. Continue this process until
the filter is clean. After drying, insert the cartridge back to the vacuum cleaner in the opposite
way. Close the vacuum cleaner lid by snapping it shut. You will hear a clicking sound.
Storing accessories
Accessories (crevice and upholstery nozzle) put into openable cover in cover
A2
.
Other accessories, the floor nozzle, the suction tubes and the hose can be dismantled again
or left assembled and hung on the back side or on the bottom of the vacuum cleaner into the
storage position (Fig. 20). For better stability, slide individual parts of the tube to each other
so that the tube is as short as possible.
29
GB
28 / 48
