eta BE-P3, Руководство по установке

Страница: 15 / 20

Concluding activities Setting node numbers
15
4 Concluding activities
4.1 Setting node numbers
Set node number
Setting the node number on the new control panel set
is only required if several control panels are present in
the system. If only one control panel is present, the
factory setting is suitable and this step can be skipped.
4.1.1 Up to software version X.35.X
Set node number on ETAtouch control panel
1) Switch on the entire heating system.
2) On the ETAtouch control panel, press .
3) Press [Change authorisation].
4) Raise the access level to [Service].
5) Press [System configuration].
A window with the system settings appears.
6) Press the [Change] button next to [CAN node
switch].
A window appears where you can enter the
desired node number.
The values 0 to 7 are permitted for the node
numbers.
7) Press [Accept].
8) Restart the entire heating system.
The change will only take effect after the restart.
4.1.2 Software version X.36.0 and later
Set node number on ETAtouch control panel
1. Switch on the entire heating system.
2. On the ETAtouch control panel, increase the au-
thorization level to [Service].
3. Press the [CAN network] button. A window
appears where you can enter the desired node
number.
The values 0 to 7 are permitted for the node
numbers.
4. Restart the entire heating system. The change will
only take effect after the restart.