eta BE-P3, Руководство по установке

Страница: 10 / 20

10 www.eta.co.at
Exchange for HACK, SH, PE-K Installation
Enlarge cut-out for the new control panel (if
desired)
The new control panel protrudes slightly due to the
existing cut-out in the cover. See the following graphic.
Fig. 3-12: Side view with existing cut-out
If this is not desired, the cut-out can be enlarged
so that the new control panel is more flush with
the cover. A cutting template for this can be seen in
chapter
5 "Cutting template" .
Fig. 3-13: Side view with enlarged cut-out
Fig. 3-14: Cutting template
After cutting out, seal the cut edges with a coating
to prevent rust from building up.
Mount new control panel
The two side tabs on the retaining plate of the new
control panel can be broken off. They are already
perforated for this purpose. Breaking off the tabs is
only necessary if the cut-out in the cover has
not been
enlarged.
Fig. 3-15: Break off tabs
Insert the new control panel and carefully attach it with
the retaining plate and two screws. Note the correct
alignment of the control panel. The ETA logo must be
on top.
Fig. 3-16: Attachment (original cut-out)