eta 90030, Инструкция по эксплуатации

Страница: 20 / 44

Full dust filter signaling (A8)
If the coloured field is displayed permanently on the indicator while the floor nozzle is
lifted above the cleaned surface at the maximum suction power , the dust filter must be
replaced. Disregard changes on the indicator during vacuuming.
Replacing the dust filter
Tip out the lid A2 of the cleaner by pressing closure A4 (pic. 12). Pull the dust filter A13
out of the guiding grooves of the holder A12 (pic. 13) and dispose it with common house
waste. Slide the front of the dust filter into the holder in the suction space of the vacuum
cleaner and push it all the way. Press to close the lid of the cleaner.
Replacement of textile dust filter ( C2 )
Textile filter can be used for all types of the vacuum cleaner. However, it is not supplied
as a part of the type, but you can buy it separately (as a spare part). Textile dust filter has
the function of the paper / synthetic dust filter and it replaces it fully. The process of its
inserting and removing is the same as the process of replacement of the paper / synthetic
dust filter. The textile dust filter is intended for repeated use.
Proceed followingly when emptying the textile filter
1) Remove the filter and take off the securing lath (pic. 14), the textile filter will open and
the dust can be dumped. The filter needs to be dusted (pic. 15).
2) Put the lath on reversely. Slide the textile dust filter back on the guiding ribs in the
suction space of the cleaner as described above.
Important precautions
Do not wash, soak etc. the textile dust filter, do not use a damaged textile dust filter! Safety
lock will not allow the lid to close if you forget to insert the dust (paper or textile)
filter.
UniBag: hold adapter D and remove it from the guide ribs of holder by pulling it
(Fig. 19). By lifting off lock stop D1 , dust filter A13 will be released from the
holder/adapter (Fig. 20). Dispose of the dust filter with common municipal waste.
Slide the projections on the front of a new dust filter into the holes in adapter
D and secure the front by slight pushing. You will hear a clicking sound. Check
proper fastening of the front by slight pulling of the dust filter. Slide the adapter
with a filter to the holder in the suction space and push it to the maximum
position.
Replacing micro-filters
After replacing about 5 dust filters, micro-filters must be cleaned or replaced with new
ones. Dispose of the used dust filter and the micro-filters with common municipal waste.
You can buy replacement filters and micro-filters in electro store chain.
Suction microfilter
Pull out the microfilter A14 in the suction space (pic. 13). Replace the microfilter properly
behind the two protrusions and slide it into the suction space all the way. Make sure that
the bearing area and sealing elements are functional.
20
GB