eta 339390001, Инструкция по эксплуатации

Страница: 82 / 148

EN - 82
EN
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the dishwasher,
deposits will form on the dishes and utensils. The appliance is equipped with a special softener
that uses a salt container specifically designed to eliminate lime and minerals from the water.
B. LOADING THE SALT INTO THE SOFTENER
Always use the salt intended for use with dishwasher.
The salt container is located beneath the lower basket and should be filled as explained
in the following:
ATTENTION!
• Only use salt specifically designed for the use in dishwashers! Every other type of salt not
specifically designed for the use in a dishwasher, especially table salt, will damage the water
softener. In case of damages caused by the useofunsuitable salt the manufacturer doesnot
give any warranty nor is liable for any damages caused.
• Only fill with salt just before starting one of the complete washing programs. This will prevent
any grains of salt or salty water, which may have been spilled, remaining on the bottom
of the machine for any period of time, which may cause corrosion.
Open
A
After the lower basket has been removed, unscrew and remove the cap from the salt
container.
1
B
Place the end of the funnel (supplied) into the hole and introduce about 1.5 kg of dishwasher
salt.
2
C
Full fill the salt container with water,It is normal for a small amount of water to come out
of the salt container.
D
After filling the container, screw the cap tightly back clockwise.
E
The salt warning light will stop being after the salt container has been filled with salt.
F
Immediately after filling the salt into the salt container, a washing program should be started
(We suggest to use a short program). Otherwise the filter system, pump or other important
parts ofthe machine may be damaged by salty water. This is out of warranty.
NOTE
• The salt container must only be refilled when the salt warning light in the control panel
comes on. Depending on how well the salt dissolves, the salt warning light may still be on
even though the salt container is filled. If there is no salt warning light in the control panel
(for some Models), you can estimate when to fill the salt into the softener by the cycles that
the dishwasher has run.
• If there are spills of the salt,a soak or a rapid program should be run to remove the exce -
ssive salt.