eta 339390001, Инструкция по эксплуатации

Страница: 104 / 148

EN - 104
EN
Noise
Problem Possible Causes What To Do
Knocking noise in the
wash cabinet
A spray arm is knocking against an
item in a basket
Interrupt the programme, and rearrange
the items which are obstructing the spray arm.
Rattling noise in the
wash cabinet
Items of crockery are loose
in the wash cabinet
Interrupt the programme and rearrange the items of
crockery.
Knocking noise in the
water pipes
This may be caused by on-site installation
or the cross-section of the piping.
This has no influence on the dishwasher function.
if in doubt, contact a suitably qualified plumber.
Unsatis - factory
washing result
The dishes are not
clean
The dishes were not loaded correctly. See notes in “Loading the Dishwasher Baskets“.
The programme was not powerful
enough.
Select a more intensive programme. See“ Wash
Cycle Table „.
Not enough detergent was dispensed. Use more detergent, or change your detergent.
Items are blocking the path of spray
arms.
Rearrange the items so that the spray can rotate
freely.
The filter combination in the base of
wash cabinet is not clean or
is not correctly fitted. This may cause
the sp ay arm jets to get blocked.
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See „Cleaning
the Spray Arms“.
Cloudiness on
glassware
Combination of soft water
and too much detergent.
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Black or gray marks on
dishes
Aluminum utensils have rubbed again -
st dishes.
Use a mild abrasive cleaner to eliminate those
marks.
Detergent left in dispen-
ser cups
Dishes block detergent cups. Re-loading the dishes properly.
Unsatis - factory
washing result
The dishes are not
drying
Improper loading
Load the dishwasher as suggested
in the directions.
Too little rinse-aid
Increase the amount of rinse-aid/refill
the rinse-aid dispenser
Dishes are removed too soon
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam
can escape. Begin unloading the dishwasher only
once t he dishes are barely warm to the touch.
Empty the low basket first. This prevents water form
dropping off dishesin the upper basket.
Wrong program has been selected
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose a
program with a long washing time.
Use of cutlery with a low-quality
coating
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
ERROR CODES
When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings Possible Causes
E1 Longer inlet time.
Faucets is not opened,
or water intake is restricted,
or water pressure is too low.
E3 Not reaching required temperature. Malfunction of heating element.
E4 Overflow. Some element of dishwasher leaks .
E8 Divider valve failed Divider valve failed
Ed
Failure of communication between
main PCB with display pcb
Open circuit or break wiring for the
communication
WARNING
• If overflow occurs, turn off the main water supply before calling a service.
• If there is water in the base pan because of an overfill or small leak, the water should be
removed before restarting the dishwasher.