EN
EN - 92
When to Refill the Rinse Aid Dispenser
•
If there is rinse-aid warning light in the control panel.et below 1/4 full.
•
As the rinse aid diminishes, the size of the black dot on the rinse aid level indicator
changes, as illustrated below.
Remove the rinse reservoir
cap by lifting up the handle.
Pour the rinse aid into the
dispenser, being careful
not to overfill.
Close the cap after all.
ATTENTION!
Clean up any rinse aid split during filling with an absorbent
cloth to avoid excess foaming during the next wash.
Adjusting rinse aid dispenser
Follow the below steps:
1. Open the door, turn on the appliance with the
ON/OFF
button.
2.
Within 60 seconds
after step 1, press the
Program
button more than 5 seconds, and
then press the
Delay
button to enter the set mode, the rinse aid indication blinks.
3. Press the
Program
button to select the proper set according to your using habits, the
sets will change in the following sequence: D1>D2>D3>D4>D5>D1.
The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the
power
button to exit the set mode, the set
success.
NOTE
Increase the dose if there are drops of water or lime spots on the
dishes after washing. Reduce it if there are sticky whitish streaks
on the dishes or a bluish film on glassware or knife blades.
Содержание 239490001E
Страница 159: ...HU HU 159 X TECHNIKAI INFORM CI 610 csukott ajt val 448 845 1175...
Страница 162: ...HU HU 162 Megjegyz sek...
Страница 163: ...HU HU 163...
Страница 164: ...10 06 2021...
