eta 239490001E, Инструкция по эксплуатации

Страница: 113 / 164

EN
EN - 113
About Electricity Connecting
CAUTION!
for personal safety: DO NOT USE AN EXTENSION CORD OR AN ADAPTER
PLUG WITH THIS APPLIANCE. DO NOT, UNDER ANY CIRCUMSTANCES, CUT
OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD.
ELECTRICAL REQUIREMENTS
Please see the rating label to know the rating voltage and connect the dishwasher to
appropriate power supply, which has a required fuse 10 amp. Time delay fuse or circuit
breaker recommended and provide separate circuit serving only this appliance. Insure
propar ground
ELECTRICAL CONNECTION
After making sure that the voltage and the frequency values for the current in the home
correspond to those on the rating plate and that the electrical system is sized for the
max. voltage on the rating plate, insert the plug into an electrical socket which is earthed
properly. If the electrical socket to which the appl iance must be connected is not
appropriate for the plug, replace the socket,rather than using a adaptors or the like as they
could cause overheating and burns.
GROUNDING INSTRUCTION
• This appliance must be grounded. In the event of a malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance of electric current.
• This appliance is equipped with a cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into an appropriateoutlet that is installed
and grounded in accordance with all local codes and ordinances.
WARNING!
Improper connection of the equipment-grounding conductor can result
in a risk of electric shock. Check with a qualified electrician or service
representative if you are in doubt whether the appliance is properly
grounded. Do not modify the plug provided with the appliance; If it is not fit
for the outlet. Have a proper outlet installed by a qualified electrician.
Water Connection
WARNING!
In order to avoid that there is more water staying in the inlet hose, please
close the hydrant after using.(For the models: no safety inlet hose.)
HOW TO CONNECT A SAFETY AQUASTOP HOSE:
The appliance must be connected to the water supply with new hoses. Old set of hoses
should not be used repeatedly! The water pressure must be between 0.04 MPa and 1 MPa.
1. Pull out the AQUAstop safety hose from the transport location on rear wall of the dishwasher.
2. Screw the AQUAstop hose to the faucet (3/4 inch threaded)
3. Turn on the water supply before turning on the dishwasher.