eta 110090010, Инструкция по эксплуатации

Страница: 27 / 56

Warning
If the blender runs idle (e.g. the blade cannot touch the ingredients), disconnect it from
the mains and release the ingredients. The blender cannot run idle for more than 10
seconds!
II. FEATURES OF THE DEVICE (PIC. 1, 2 , 3)
A – propulsion unit
A1 – propulsion shaft
A2 – rubber feeder
A3 – locking mandrel for attaching the
container
A4 – supply cord
B – control panel
B1 – display
B2 – “+” button to manually set speed /
processing time (increase in value)
B3 – “-” button to manually set speed /
processing time (decrease in value)
B4 – function button to set processing
time
B5 – function button to set speed
B6 – quick set button for the
“SMOOTHIE” programme
B7 – PULSE button to set the maximum
rotation speed
B8 – quick set button for the “QUICK
CLEAN” programme
B9 – “MENU” button for selection of
a pre-set programme (MILK, NUTS,
ICE, PUREE)
B10 – POWER button to start/end the
processing programme
C – dish
C1 – handle
C2 – knife
C3 – gasket no. 1
C4 – gasket no. 2
C5 – nut
D – lid
D1 – plug
D2 – lid seal
E – pusher
F – release lever
G – sports bottle for beverages
(2 pcs)
H – thermo insulated cover for sports
bottle (2 pcs)
III. PREPARATION FOR USE
Remove all packaging material, remove the accessory. Remove all adhesive foils, stickers
or paper from the appliance. Before the first use, wash the parts that will be in contact with
food in hot water with a detergent, rinse them thoroughly with clean water and wipe till dry,
or let them dry. Possible short-time mild smoke when the appliance is operated for the first
time is not a defect and the appliance is not subject to a complaint for this reason.
Appliance assembling
(Fig. 1)
Please assemble the appliance according to Fig. 1. If you properly put the container
C
on
the driver unit, the safety clutch will be released, and you can start using the appliance.
Insert the cap D1 or stamper E in the lid opening. Apply the reverse procedure to
dismantle.
27
GB
/ 51