2
We strongly recommend that a set of safety infra red beams (ET BLUE I’s) be used for additional
protection.
DO NOT operate the Garage door operator while a person, especially a child is near the door.
Children must be under adult supervision at all times near an automated garage door especially
whilst the operator is in use.
Ensure that the BUILT IN SAFETY OBSTRUCTION SENSING SYSTEM (Load sensing) is correctly setup.
Regular testing (Monthly) is advised and adjustment must be made if necessary.
DO NOT pull the Manual release cord that changes the operator to manual operation whilst any
person or object is near or under the path of the door. If possible always change the operator to
manual mode with the door in the full closed position.
Connect the operator’s 220Vac mains cord to properly earthed mains. Installation and wiring must
comply with local council electrical code. (Enquire at your local municipality for a certified electrician
if uncertain)
DISCONNECT electrical power before undertaking any repairs to the garage door operator. Only
experienced professional personnel should remove the covers.
Keep hands and or other parts of the body, as well as loose items of clothing, clear of the door and
operator while operating or servicing.
In applications where “auto-close” is required, a set of safety infra red beams (ET BLUE I’s) MUST be
installed. The safety device must be tested regularly (Monthly) for correct operation. EXTREME
CAUTION is necessary when setting an operator to “auto-close” mode. Safety rules must be adhered
to at all times. Some regions SAFETY CODES OF PRACTICE disallow the use of “auto-close” in garage
door automation. If uncertain rather don’t make use of this feature, or investigate further.
The SAFETY OBSTRUCTION SENSING SYSTEM (Load sensing) is only activated when a certain level of
resistance (Resistive Force) is exerted onto both the door and object/person obstructing the travel. As
a result, the object/person may suffer a degree of DAMAGE or INJURY relative to the SAFETY REVERSE
SYSTEM (Load sensing) setting. It is strongly recommended that SAFETY INFRA RED BEAMS (ET BLUE I’s)
be installed to increase the safety level.
Ensure that the door is fully open before passing through the doorway and fully closed before leaving
the area.
Keep the door in CLEAR LINE OF SIGHT whenever operating.
