21
Introduction to the operating structure
Configuration POM
8. Configuration POM (Programming on the Main)
The SwitchPilot 3 Plus may remain installed on your layout during
programming. For POM to work, your command station must also
support „Programming on the Main (POM)” for accessory deco-
ders (!). Thanks to RailCom®, ECoS owners can even read out the
values (see chapter 11).
8.1. Connection to the digital system
The SwitchPilot 3 Plus does not require any special connections. It
may remain wired as shown in chapter 5.2. respectively 5.3.
8.2. Reading and writing CVs with POM
Select “POM” as well as „Accessory decoder” on your command
station. Make sure that the correct accessory address is selected (it
must be the first one!).
Figure 14: SwitchPilot connection to the LokProgrammer
To the
LokProgrammer
7. Configuration with LokProgrammer
Please always use the latest PC software for your LokProgrammer,
but at least version 5.1.0. To ensure a correct reading, connect the
SwitchPilot 3 as shown in Fig. 14 (
Pw A
and
Pw B
).
Figure 15: Programming on the main with ECoS
ADDRESS
Switch 1-4: 0001-0004
Switch 5-8: 0005-0008
Содержание SwitchPilot 3 Plus
Страница 35: ...35...
