Esu SwitchPilot 3 Plus, Инструкция по эксплуатации

Страница: 10 / 36

10
5. Connection to the digital system
We recommend that you first configure the SwitchPilot 3 Plus de-
coder completely and then install it on the layout.
5.1. Terminals
Fig. 5 shows the SwitchPilot 3 Plus with all terminals.
a) Turnouts, daylight signals, uncouplers and similar electric loads
shall be connected to the terminals labelled 1 to 8 for the out-
put pairs 1 to 8.
b) The power supply of the SwitchPilot 3 Plus including all con-
nected loads is realized vie the Terminals Pw A and Pw B. You
can either use the track voltage or use an external power sup-
ply. We recommend an external power supply, particularly for
larger layouts, because then the energy for powering the drives
does not add to the load for the command station or booster.
c) Connect the Terminals Trk A and Trk B to the track output of
the command station (or booster) that controls the SwitchPilot
Plus 3.
e) Input unit. The three buttons PROG/OK as well as (+) and (-)
serve to configure the decoder, as explained in chapter 6.
f) The display shows all settings of the decoder including turnout
address and status of the outputs. After a few seconds, the
screen saver displays the supply voltage.
g) Extension socket for the SwitchPilot Extension relay module.
Figure 5: Terminals of the SwitchPilot 3 Plus
Connection to the digital system
g)
f)
e) c)
b)
a) a) a) a)
g)