12
6.1.4. Cylinder steam function
You can use the «big» smoke generator 54679 setting the jumper
so that it works in the «cylinder steam»(see Figure 2). This means
in practice, that with two smoke generators located in the loco-
motive you need to take care in using the correct wiring so that
both smoke generators have a power supply (red cable to U +
terminal of the decoder, the black wire to the GND terminal the
decoder)and both receive it and that both the above commands
get the AUX1 output in parallel. The cylinder steam required no
steam burst trigger (green wire).
You now only have the sound outlet for the noise «cylinder blow
out» the corresponding values for the heating and setting the fan
speed. In our example, this is stored in the sound slot 9 «cylinder
blow out». The LokSound decoder is at all sound slots> 4 and as-
sumes that the cylinder steam must act and sends the appropriate
commands to the smoke generator.
Be sure to set both the CV values and also the sound again on
the decoder. The flue settings can be written together with the
sound data.
6.2. For other decoder (SUSI)
When operating with other decoders from the SUSI interface
usually only the current speed and the condition the function keys
transmitted. The smoke generator must piece together the data in
conjunction with the steam pulses. For this to succeed in practice,
ESU smoke generators have some SUSI CVs.
Once you have connected the smoke generator you must program
these CVs to matching. This is done on the programming track as
with «normal» CVs too. The decoder is normally sufficient on the
SUSI CVs to the smoke generator and can also be read.
6.2.1. Function key
First, you must determine which function key the smoke generator
will be switched on with. The desired key is defined in the CV 902.
The work value «1» stands for F1.
6.2.2. Heating and fan speed monitoring
The smoke generator recognizes SUSI Mode in 4 states:
Stop: The model is stopped, the fan is running
•
Drive: The model runs
•
Acceleration: The model accelerates
•
Coast: The model rolls (controller was turned back from state
•
drive)
Relationships
Figure 15:
Acceleration
Coast
Stop
Drive
Programming
Cylinder steam
Figure 16:
