ESTEBAN WOOD & LIGHT EDITION, Инструкция по применению

Страница: 6 / 24

10 11
STARTING THE DIFFUSER
Read the below-mentioned instructions carefully before starting the diffuser.
1
2
3
STAGE 1
STAGE 2
STAGE 3
• Place the diffuser on a flat and stable surface away from the edge.
• Connect the electricity cable to the port at the back of the diffuser without plugging it in.
• Remove the upper part A. Pour water at room temperature into the container C.
Do not exceed the maximum
level of 100 ml
. (Warning: the diffuser does not work if the water level is too low or higher than 100 ml).
• Do not pour hot water into the container (risk of damage of sensitive components).
• Add 10 to 15 drops of Estéban refresher oils or essential oils, depending on the required intensity (the harshest and
most viscous essential oils should not be used as they may damage your diffuser).
-

Do not pour drops of refresher oils or essential oils into the container if there is no water
in it as this risks damaging the device.
- Wipe up any drops that may accidentally have fallen outside the container.
- An excess of refresher oils or essential oils could prevent the diffusion and damage the diffuser.
• Place the upper part A back on the diffuser base C.
• Do not move the diffuser once you have filled it.
• Plug the appliance into a (mains) socket. Only use the electricity supply intended for this
purpose. Check that the electric plug is in conformity with your country’s electricity
installation. If not, add a universal adapter to the plug (see non-exhaustive list of countries
on page 8).
• In order to avoid any accident, make sure that the cable is not located in an area where
people walk.
• To start the diffuser, press the following buttons:
• Mist button (4):
- One press: diffuses continuously.
- 2 nd press: diffuses every 30 seconds.
- 3
rd
press:
stops the diffusion (otherwise, the diffuser stops automatically after a time).
• Light button (5):
- One press: enlivening, intense light.
- 2 nd press: soft, soothing light.
- 3
rd
press: switches off the light.
• The appliance stops automatically if there is not enough water.
• During the diffusion, the height of the mist may vary.
• When the appliance is operating, make sure not to put any obstacle above the appliance that could hamper the release of
the mist and not to remove the upper part in order to avoid any splashing.
4
5
4
STAGE 4
• Unplug the appliance, then empty out the remaining water by following the diagram opposite and clean it (refer
to the «CLEANING» recommendations in the operation and maintenance instructions).
GB GB