15
po.org
MODEL: EST-MTB24G PRODUCT CODE: 705558 | MODEL: EST-MTB24B PRODUCT CODE: 705559 11/2021
AFTER SALES SUPPORT
info@tem
AUS
1300 112 534
Assembly (Cont.)
Step 6: Installing the Reflectors and Bell
CAUTION!
Be sure the reflector is in the same longitudinal plane as the bicycle (vertical
to the ground). If the reflector is aimed up or down, oncoming headlights may
not reflect properly in the reflector. If the reflector is not vertical to the ground,
loosen the clamp screw and readjust the angle.
It is important to check and adjust the position of the reflectors as you
assemble your bike. The reflectors must always be vertical (perpendicular to
the ground) and pointed toward the front and rear of the bike.
1. Remove the clamp screw from the reflector (or bell) bracket.
2. Push open the bracket loop and slide it onto the handlebar. (If there is a sizing
insert included with the bracket, please be sure it is inside the clamp loop before
mounting.)
3. Position the bell bracket (Fig. 14) or the reflector bracket (Fig. 15) at a certain
position on the handlebar and tighten the clamp screws securely.
Rear reflector (red)
1. Put the seat post mounted rear reflector
in the correct position by loosening
the screws of the rear reflector bracket
(Fig. 16).
2. Make sure the rear reflector is vertical to
the ground and points straight back.
3. Make sure there is a minimum clearance of
7.5 cm between the top of the seat and the
top of the red rear reflector.
Fig. 14
Fig. 15
Fig. 16
