PREPARATION
Remove parts from laser-cut panel and group as shown
above.
VERTICAL FIN and RUDDER
1.
Sand trailing edges of rudder sheets(R1, R1a).
2.
Glue sub leading edge(R2) and ribs(R3-R4) on the
outboard rudder sheet(R1a) with thin CA and then
apply
thick CA glue at each joints for reinforcing
.
3.
Cover the inboard rudder sheet(R1) with
thick CA
.
4.
Glue the rudder leading edge(R5) with
thick CA
.
5.
Glue vertical fin sheets(V1a-V2, V1b-V2) together.
6.
Lay elevator servo extension cord and glue the parts(V3-
V10) on the outboard vertical fin sheet(V1a,V2) with thin CA
and
apply thick CA glue at each joints for reinforcing
.
Note
Elevator servo extension needed right vertical fin only.
7.
Make notch for extension on the V5a part and glue.
8.
Cover the inboard vertical fin sheet(V1b,V2) with
thick
CA
.
9.
Glue the fin leading edge(V11) and trailing edge(V13) with
thick CA
.
Glue the parts (V12,V14,V15) with
thick CA
.
Note
To fit center, use cardboard as shown above.
Page 2
