15.
Install main gear and then fix plywood retainers (B14)
with screws. Fix wheels with wheel collars.
16.
Glue hinges to the stabilizer with small amount of thin CA
and then, connect elevator pushrod.
17.
Fix battery with Velcro tape.
Install switch and charge connector on the bottom of
fuselage.
18.
Install canopy, rear cone and flap joiner cap with scotch
tape.
Check CG. (CG location is shown on the drawing.)
Congratulations! Enjoy flying.
With Landing gear.
Without Landing gear / Retracts.
Control Throws
The following control throws are recommended starting
points. After you are familiar with this plane, you may
increase, or decrease.
- Ailerons : 19mm(5/8
”) up, 16mm(5/8”) down.
- Elevator : 16mm(5/8
”) up and down.
- Rudders : 16mm(5/8
”) right and left.
- Flaps : takeoff-15degrees(16mm), landing-
35degrees(37mm)
(Flap-elevator down mix is required.)
Page 11
