Start the cycle.
Release the pressure on the white circles so the rear tab goes into the slit located opposite the cylindrical
white pins (next to you - see illustration below).
Check that the pattern holder does not move in the table.
Tracing
Press
to start mechanical tracing.
To interrupt tracing at any time, press
.
The tracer automatically detects the pattern holder.
The buttons
,
,
and
are displayed.
Select the eye to be traced.
The numeric keypad is displayed.
Enter the D-dimension value, then press
to confirm.
The tracing result is displayed in the centering screen, in monocular format on a 1:1.6 scale.
Tracing - tracing mode
In tracing - tracing mode, the result of the tracing is displayed in the work area of the tracing screen.
For more information on working modes, refer to the section Tracing > Tracing environment > Jobs
and working modes.
(
F
p.21)
.
>
>
>
>
3
4
5
1
2
3
U
SER
M
ANUAL
> II. T
RACING
37
Pro-B 300 > v1.0 - 03.19
Содержание Pro-B 300
