Espa SPEEDRIVE, Инструкция по эксплуатации

Страница: 5 / 24

- 5 -
3.2.2) Speedrive with three
3.2.2) Speedrive with three 3.2.2) Speedrive with three
3.2.2) Speedrive with three----phase input (Figure 2):
phase input (Figure 2): phase input (Figure 2):
phase input (Figure 2):
The motor must be connected to a 400 V power supply source.
The cable (1) supplied with the frequency inverter must be connected to the motor.
If you wish to activate the 60Hz motor output, select the corresponding parameter in the menu.
Make sure that electrical consumption shown on the motor's data plate does not exceed that supplied by the
inverter.
DANGER.
Risk of electrocution. Always connect the supplied grounding cable (2) between the motor
and inverter set.
DANGER.
Risk of electrocution. Never open the Speedrive cover before disconnecting the power
supply during at least 5 minutes
least 5 minutes least 5 minutes
least 5 minutes.
Figure 2 Figure 2 Figure 2 Figure 2
3.3) Installation on the pump. 3.3) Installation on the pump. 3.3) Installation on the pump. 3.3) Installation on the pump.
The Speedrive is installed on the motor with a special supplied adapter.
The inverter is cooled with the use of the motor's cooling elements.
The unit has been designed for vertical and horizontal installation.
3.3.1) Motor adapter (Figure 3):
3.3.1) Motor adapter (Figure 3): 3.3.1) Motor adapter (Figure 3):
3.3.1) Motor adapter (Figure 3):
Replace the connections box with the supplied motor adapter. Use the same screws. Torque 1~1.2 Nm.
Figure 3
Figure 3 Figure 3
Figure 3
Azul
Marrón
Negro
Blue
Brown
Black
Yellow/Green