14
6.1.2
2., 3., 4. Relay Output Settings (OUT-2-3-4)
In this menu you can set the relay outputs 2, 3 and 4 of your EPA300. Complete
settings 5.1.1. The 1 st relay output described in chapter is the same as the OUT-1
settings.
6.1.3
Current and Voltage Analog Output Settings (ANLOG)
If your EPA300, which is manufactured specifically for your order, has an analog
output module, you can make the necessary settings from this menu.
Select the analogue output from the
TYPE
menu:
From the
COND
menu, select whether the analogue output module is active or not.
Use ON to activate or OFF to activate.
From
InvrS
menu, you can choose which value to increase or decrease according to
the sensor reading on the analogue output. This option, which is OFF by default,
provides an analog output that increases or decreases in proportion to the value
read at the sensor. If you turn this ON, the value read out at the sensor will increase
while the value at the analog output will decrease, ie an inversely proportional
output will be provided.
Wave Form (VAVE.F.)
The waveform of the output signal can be selected from the Vave.f menu. There are
4 options in the menu: Liner, Sin, Cos, Trian. When the liner option is confirmed with
the PRG key, a linearly increasing waveform is obtained in the specified scale range.
When the Cos option is confirmed with the PRG key, a waveform in the form of a
waveform that starts from zero and completes a complete cosine wave is obtained
at the scale interval specified. When the Sin option is confirmed, a waveform in the
form of a waveform that starts at the peak value of the sine wave and completes a
complete sinusoidal wave in the determined scale range is obtained. When the
triangle option is selected in the same way, a triangle wave is obtained in the scale
interval determined at the exact middle value corresponding to the top.
Analog Output Scale Setting (Scale)
In the device with the analogue output feature, SCALE mode in this menu must be
ON to set the output signal to the desired scale range. S-LO started appearing on the
analogue menu afterwards. And S-HI. Options and scale values can be entered.
0.5 - 4.5 Volt
0 – 20 mA
0 - 10 Volt
4 - 20 mA
0 - 5 Volt
.
.
.
.
.
